Sangam: A Confluence of Knowledge Streams

Sustaining membrane permeability during unsteady-state operation of anaerobic membrane bioreactors for municipal wastewater treatment following peak-flow

Show simple item record

dc.creator Wang, Kanming M.
dc.creator Jefferson, Bruce
dc.creator Soares, Ana
dc.creator McAdam, Ewan J.
dc.date 2018-08-20T09:13:20Z
dc.date 2018-08-20T09:13:20Z
dc.date 2018-07-23
dc.date.accessioned 2022-05-25T16:37:48Z
dc.date.available 2022-05-25T16:37:48Z
dc.identifier Wang KM, Jefferson B, Soares A, McAdam EJ.,Sustaining membrane permeability during unsteady-state operation of anaerobic membrane bioreactors for municipal wastewater treatment following peak-flow. Journal of Membrane Science, Volume 564, Issue October, 2018, pp. 289-297
dc.identifier 0376-7388
dc.identifier http://dx.doi.org/10.1016/j.memsci.2018.07.032
dc.identifier http://dspace.lib.cranfield.ac.uk/handle/1826/13414
dc.identifier.uri http://localhost:8080/xmlui/handle/CUHPOERS/182272
dc.description In this study, the impact of peak flow on anaerobic membrane bioreactor operation is investigated to establish how system perturbation induced by diurnal peaks and storm water flows will influence membrane permeability. Good permeability recovery was attained through increasing gas sparging during peak flow, which was explained by the transition in critical flux of the suspension at higher shear rates. However, supra-critical fluxes could also be sustained, provided peak flow was for a short duration. We suggest longer durations of supra-critical operation could be sustained through introduction of reactive fouling control strategies (e.g. TMP set-point control). An initial flux below the critical flux, prior to the introduction of peak flow, was advantageous to permeability recovery, suggesting membrane ‘conditioning’ is important in governing recoverability following peak flow. The importance of conditioning was confirmed through analysis of multiple peak flow events in which the loss of permeability following each peak-flow event was increasingly negligible, and can be ascribed to the arrival of a steady-state in membrane surface deposition. Whilst responding to peak flow with increased gas sparging has been shown effective, the energy demand is considerable, and as such a pseudo dead-end filtration strategy was also evaluated, which required only 0.04 kWh m−3 of energy for gas sparging. Comparison of both filtration modes identified comparable fouling rates, and the feasibility of a low energy gas sparging method for peak flow management that has successfully enabled supra-critical fluxes to be achieved over long-periods in other MBR applications. Importantly, membrane area provides the highest contribution toward capital cost of AnMBR. The potential to turn-up flux in response to peak-flow has been identified in this study, which suggests membrane area can be specified based on average flow rather than peak flow, providing substantial reduction in the capital cost of AnMBR for municipal wastewater treatment.
dc.language en
dc.publisher Elsevier
dc.rights Attribution-NonCommercial-NoDerivatives 4.0 International
dc.rights http://creativecommons.org/licenses/by-nc-nd/4.0/
dc.subject Unsteady-state
dc.subject Diurnal flow
dc.subject Capital cost
dc.subject Membrane design
dc.title Sustaining membrane permeability during unsteady-state operation of anaerobic membrane bioreactors for municipal wastewater treatment following peak-flow
dc.type Article


Files in this item

Files Size Format View
Sustaining_memb ... y-state_operation-2018.pdf 1.951Mb application/pdf View/Open

This item appears in the following Collection(s)

Show simple item record

Search DSpace


Advanced Search

Browse